系统接口电路应能够适配连接系统的物理特性。

单选题系统接口电路应能够适配连接系统的物理特性。

A、 The system interface circuits control the physical properties of the connected systems.

B、 The system interface circuits adapt to the physical properties of the connected systems.

C、 The physical configuration of the connected systems defies the behavior of the system interface circuits.

由4l***yw提供分享举报纠错

相关试题

单选题确保襟翼收回，并且使副翼配平手轮处于零位。

A、Make sure that the flaps are retracted and the aileron trim handwheel is in the zero position.

B、Ensure that the flaps are partially extended and the aileron trim handwheel is centered at zero.

C、Make sure that the flaps are raised and the aileron trim handwheel is set to non-zero position.

单选题在这种配置中，液压会旁通此阀门。

A、The valve allows the hydraulic pressure to pass through in this configuration.

B、The hydraulic pressure is blocked by the valve in this setup.

C、In this configuration, the hydraulic pressure bypasses the valve.

单选题确保箭头指向燃油流量流动的方向。

A、Ensure that the arrow points in the direction of fluid flow.

B、Make sure that the arrow points in the direction of the fuel flow.

C、Ensure that the arrow points in the direction of fluid supply.

单选题当拉动下部轴承时，可以看到下部的封圈。

A、The lower seal is invisible prior to switching the lower bearing on.

B、The lower seal becomes visible when you push the lower bearing up.

C、The lower seal comes into view when you pull the lower bearing down.

单选题关于如何在恶劣天气下停放的说明，请参阅第6章。

A、The instructions for taxing in bad weather conditions are found in chapter 6.

B、Chapter 6 provides instructions on pulling up in normal weather conditions.

C、Refer to chapter 6 for instructions on how to park in bad weather conditions.

单选题始终保持液晶显示器的亮度旋钮设置在最大位。

A、Always keep the brightness control on the LCD display at maximum.

B、Always keep the brightness knob of the LCD monitor set to its maximum dimness position.

C、Always adjust the test knob of the LCD monitor set to maximum brightness position.

单选题完成步骤1到4，确保没有轴向负载施加在连杆上。

A、Finish stage 1 to 4 to ensure that no axial force is derived from the rod.

B、Do steps 1 thru 4 to make sure that no axial load is applied on the rod.

C、Procedures 1 to 4 are designed to check if the rod exerts axial force.

单选题为了快速拔掉销子，手动将盖子向一个方向转动，然后再向另一个方向转动。

A、Turn the canopy manually clockwise to make the pin removal process easier.

B、To make pin removal easier, manually turn the canopy in one direction and then in the other.

C、Rotate the canopy in one direction and then in the other to hinder the removal of the pin.