A01

remote office An untrained local field technician will do the rollout of the switches and the mounting

of several A5s and A5S. Cables running to theAPs are not labeled.

The VLANs are already preconfigured to VLAN 100 (mgmt), VLAN 200 (clients), and VLAN 300 (guests)

What is the correct configuration to ensure that APs will work properly?

based on their specific job requirements After the configuration was complete, it was noted that a

user assigned with the administrators role did not have the appropriate level of access on the switch.

The user was not limited to viewing nonsensitive configuration information and a level of 1 was not

assigned to their role Which default management role should have been assigned for the user?

The design needs to do this by eliminating contention overhead by dedicating subcarriers to clients.

Which technology is the best match for this use case?

in their warehouse These new devices do not support 802 1X authentication.

How can HPE Aruba reduce the IT administration overhead associated with this deployment while

maintaining a secure environment using MPSK?

Assuming the correct layer-2 VLAN already exists how would you create a new OSPF configuration for

a separate routing table?

gateway as per Aruba recommendation?

by a client using this bonded channel as compared to an unbonded 20MHz wide channel?

configuration use in the configuration created?

information of wireless clients in their stores Which standard uses Round Trip Time (RTT) and Fine

Time Measurements (FTM) to calculate the distance a client is from an AP?

How should you establish the keepalive connection?

(The sensor has no cellular connection)